Uses
Stain-Proof provides lasting protection against water, salt and staining damage for tile, stone and grout including; engineering concrete, terracotta tile, cast stone, paving, sandstone, limestone, brick and grout. It is a penetrating, invisible and breathable sealer.
Benefits
*able to repel oils and food products – making cleaning easier;
*suitable for engineering concrete, terracotta tile, cast stone, paving, sandstone, limestone, brick and grout;
*non film-forming;
*able to work without changing the appearance of the surface - keeps the original look;
*has a 15 year written warranty;
*suitable for indoor and outdoor use;
*able to greatly reduce water uptake and minimise moss growth, freeze thaw spalling and efflorescence;
*deeply penetrating – protecting against weathering and wearing;
*very alkali resistant – won’t breakdown in contact with cement based materials;
*able to seal hairline cracks up to 0.3 mm and does not flake;
*highly water vapour permeable – able to breathe so there is no build-up of subsurface moisture allowing it dry out;
Application rates
Total application rate is approximately 1 litre per 2 to 8 square metres, depending on porosity.
How to use
1. ALWAYS TEST PRODUCT ON A SMALL AREA FIRST. Allow a 24-hour cure time. Check that the sealer does not discolor the surface. 2. Remove and repair all loose or missing grout. 3. Ensure surfaces to be treated are dry, clean and free of residues. 4. Apply when the surface temperature is below 35°C. Generously saturate the surface with product using low-pressure hand spray, a clean brush, or similar. Avoid contact with surrounding areas. 5. After 10 minutes, repeat over entire area. Total application rate is approximately 1 litre per 2 to 8 square metres, depending on porosity. 6. Allow 10 minutes for product to soak in then buff surfaces with a clean white dry cloth to remove excess product. Clean brush in mineral turps. 7. Let the product dry for a minimum of 12 hours before using the surface. 8. Sealer will not prevent surface etching or wear. Clean-up stains immediately to minimize absorption.
Active content
50% 
Pack size
1, 5 & 20 litre steel drums
Typical Applications
Rundle Street Adelaide - 1,000sq m
Factory Chatswood - 700sq m
Noosa Shopping Centre - 500sq m
Test reports
Resistance to salt attack tests on pavers - BEMAC Laboratories
Staining liquid tests to ISO 10545-14 - Eureka Tiles
Coefficient of friction of wet surfaces - BEMAC Laboratories
Recommended retail price (includes GST but excludes freight)
1 litre pack AUD 57
5 litre pack AUD 279
20 litre pack AUD 1058
Please contact us for bulk orders and freight prices.
 |
||
| InfoTile.com: Home | Sitemap | Search | Copyright © 1995-2001 InfoTile Pty. Ltd. |  |
|
||